web page hit counter

How To Cut Vinyl Siding For Ledger Board


How To Cut Vinyl Siding For Ledger Board
How To Cut Vinyl Siding For Ledger Board

How To Cut Vinyl Siding For Ledger Board. Then slip flashing behind the siding, covering the top edge of the ledger. If you've found our videos or website information helpful, please considering making a donation.

How To Cut Vinyl Siding For Ledger BoardHow To Cut Vinyl Siding For Ledger Board
Flashing deck ledger board vinyl siding Deck design and Ideas from teen10x.info

Start by making an outline on the siding where you want to position the ledger board. Then slip flashing behind the siding, covering the top edge of the ledger. Hammer the sleeve anchor through the ledger board into the concrete wall.

Snap A Chalk Line, Cut Out The Siding And Tack Up The Ledger Board.

Look for a horizontal seam between two courses of vinyl siding. Cut two 24 by 2 by 10 inch pieces of wood and scab them onto the floor joist on each side of the removed ledger. Hammer the sleeve anchor through the ledger board into the concrete wall.

More here  How To Check For App Updates On Vizio Smart Tv

After The Ledger Is Installed, You Can Do This Step If You Have Room Under The Siding.

Set the blade depth so you won’t cut into the house sheathing below the siding. You can start and stop your ledger at the vent if cutting a hole is not practical, but the ledger must be supported adjacent to the area on both sides. Remove the siding and the starter strip from the area you will be working in.

If You've Found Our Videos Or Website Information Helpful, Please Considering Making A Donation.

Cut into the wall, attach the ledger board to the rim joists and nail it to the studs. Expose the ledger board of your building by removing any siding covering the bottom of the wall where the wood meets the foundation. Use a wood bit to drill ½” pilot holes through the ledger board.

Cut Away The Rotted Ledger Board Using A Reciprocating Saw.

This will keep it tight. Cut the house wrap at the top of the ledger and apply a membrane from a couple inches up the wall down across the top of the ledger and then lay the house wrap back down over the membrane and sea with tape. Start by making an outline on the siding where you want to position the ledger board.

Drill 1/2 Inch Holes Through The Ledger Board Into The Planks Between Joists.

Expose the ledger board of your building by removing any siding covering the bottom of the wall where the wood meets the foundation. Expose the ledger board of your building by removing any siding covering the bottom of the wall where the wood meets the foundation. Slip the flashing under the siding so it will cover the ledger board.

Leave a Reply

Your email address will not be published.