close
close
How To Replace Ignition Switch On Gas Grill

How To Replace Ignition Switch On Gas Grill

How To Replace Ignition Switch On Gas Grill

How To Replace Ignition Switch On Gas Grill. Clients contact us about the ignition assembly more than any other part of any barbecue grill. New ignition electrode and turbo sts jenn air burner in bbq grill after replacing the new control valve and wiring a new ignitor system for fast east ignition.

How To Replace Ignition Switch On Gas GrillHow To Replace Ignition Switch On Gas Grill
UNIVERSAL SNAP IN GAS GRILL/ HEATER PUSH BUTTON IGNITOR SWITCH LP from www.ebay.com

A gas barbeque grill ignition system consists of several replaceable parts. Use a screwdriver to push the hinge pin out of the door frame and remove the door. Only one electrode lights the burner in this grill so the 1 wire mounts to the electrode.

Remove The Wires By Pulling Them Out Of The Old Igniter.

Manually lighting the grill to dry it out should restore the ability of the ignition system to work properly. Find the metal tab on the gas catcher above the ceramic igniter. If it has just rained, or if the humidity very high, it can interfere with the igniter electrodes ability to generate a strong spark.

See also  How To Replace Ignition Switch On Kawasaki Mule

If This Does Not Work, Contact Charbroil Customer Support Or Purchase A New Electronic Grill Ignition Kit.

Use the locknut you removed from the original igniter to secure the replacement. Clean the tip of the electrode with alcohol and try to light the grill. The module, the electrode wire, and the electrode are the primary parts although sometimes the module will be split into a spark generator, a connection switch.

The Electrode Provides The Spark To The Burner To Ignite The Gas.

Fold the tab down and the white wire connector up to free the gas catcher box from the firebox. Turn on and ignite the gas. Make note of how the grill wires enter the starter.

If You Get A Spark, The Old Electrode Is Good And Can Stay Put.

The new ignition electrodes are all plugged in to the new module so all the electrodes fire together when the button is pressed on the control panel. The last step is removing the support bracket that is held in place by four screws, two on each side. Follow the steps in this repair guide and video to.

The Electronic Ignition Sets Off A Spark When An Ignitor Button Is Pushed.

If the burner won't light, first clean and align the electrode. Replace the screws to secure the control panel. A gas barbeque grill ignition system consists of several replaceable parts.

See also  New Movie Theater Enterprise Al

Leave a Reply

Your email address will not be published.