So Basically You Need To Follow Below Steps:

The reason the code pops up is that your washer isn’t draining in the time allotted for it to. This is the closest you can get to a reset of the washer. Select the cycle you want and then press on ok.

Plug The Washer Back In And Simultaneously Hold Down The Start Button For About 10 Seconds.

Remove all laundry or any other contents in the machine. The possible issues which lead to this might be. I contacted samsung customer services who were most unhelpful;

And Delay End On The Lower Washer Control Panel Simultaneously For 3 Seconds.

What you can do instead is power cycle it: But these noises are normal and not a cause for concern. To correct the slow drain, open the bottom panel of the washer housing.

If You Need To Reset Your Maytag Washer, You Can Do So By Pushing The Power/Cancel Button.

And delay end + buttons. Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the dryer (usually 1 to 5 minutes at most), and then power it up again. Firstly, disconnect the washer from the wall socket or turn off its circuit breaker.

Using The Prefer Mode Or Smart Control Buttons.

To calibrate the lower washer. 1 hold smart control until ap displays (about 3 seconds). It needs to be at a minimum between 6 inches (15.24 centimeters) to 8 inches (20.32 centimeters) and secured with a tie so the drain hose does not slip further into the drain pipe.