How To Sharpen Reel Mower Blades With A File. Ensure that you don’t get the bearings wet; As reel mowers come with varying sizes and numbers of blades;
Now use the dragging method bring downward to beveled edge tip. The bevel’s edge and file’s angle should be on a similar plane here. Inspection of existing lawnmower blades.
Disassemble The Blade Using A Wrench.
Put grinding compound on the blades, this makes the blades into there own sharpening stones. Now, as we have already mentioned, the screws are all tightened up, and the blades are quite difficult to rotate. Make sure to choke the blades to turn on accidentally properly.
This File Sharpens Knives Faster Than Any Other Conventional Sharpening Stones.
Now that you have set everything up and prepared properly, scrape the file on the blade from 3 to 6 times. Push the mower around until it is easy, this is called lapping. The bevel’s edge and file’s angle should be on a similar plane here.
The Angle At Which The File Stands Should Be The Same As The Angle Of The Beveled Side Of The Blade.
Now at first bevel edge of a blade, you want to press the toothed end of file. You’ll start to see a flat, shiny surface on the blades where the compound has abraded away the surface and created a precise edge matched to the knife bed. After that, push the reel mower backwards so that the blades rub against each other and regain their sharpness.
Next, Press The Toothed End Of A Coarse Metal File On The Bevel Edge Of The First Blade.
Clean the blade to remove dirt and other debris holding onto it. Place the edge on a flat surface but ensure that it is elevated and held in place. These can obstruct the file.
Spin The Blades Again To Determine If Any Further Adjustments Are Needed.
Do the same thing for the back of the blade as well. Thanks to the backlapping method, we will reduce the time it takes to sharpen this blade. After that, tighten the screws once again and repeat the process.