How To Use Conair Steamer Attachments. Hold the steamer head at a minor angle up off of the surface. Once done, take out any excess water from the tank by tilting the steamer at an angle with the help of a towel.
Stand the unit on a table and grasp with one hand. Replace the water tank in the unit. If there is no evidence of damage, you can proceed to use the steamer on that item.
The Attachments After The Unit Has Been In Use, As The Steam Head Will Continue To Be Hot.
You can repeat this method a few more times, or until your steamer is putting out steam as it should be. I recently also picked up drapes and curtains and use my steamer on them as well. Check the surface behind the steamed section after steaming.
Direct The Steamer Nozzle About Half Of An Inch From The Fabric To Be Steamed.
The water reservoir can fill up to 70 ounces of water, getting heated in 40 seconds, giving up to 15 mins of steam continuously. If there is no evidence of damage, you can proceed to use the steamer on that item. I stopped using a iron months ago.
Do Not Hold Flush Against The Surface.
Fill up the water to the indicated line and allow it to heat up for around 2 minutes. Hold the steam nozzle at the base of the item. Steam will travel up the hose and any unnecessary bends will hinder the steam.
The Rubber Inlet Cover Is Located On The Top Of The Water Reservoir.
This will also hinder the ability it has to get rid of wrinkles.how to steam clotheslike ironing, when you are learning how to use a conair steamer, you will steam your clothing piece by piece.when steaming a shirt, you can use an included hand pad attachment to steam Pass the steam jets just above the fabric where the wrinkles are. My wife love the fact that use it for everything.
Begin At The Bottom Of The Fabric To Allow The Steam To Rise Inside And Outside, Removing Wrinkles.
The steamer comes with stand style base so you can rest your arm during the process. Click to see full answer. First, test unit on an inconspicuous area of the item to be steamed using the loweststeam setting to ensure fabric can tolerate the effects of steam.